The EB34TD1T-SM is an electrical emSFP transmitter module designed to convert SDI to an HDMI signal output without scaling artifacts.

The video sfp EB34TD1T-SM is an 3G/HD/SD SDI to HDMI1.4 and DVI1.0 video sfp (emSFP) converter. This video SFP is designed to convert 3G/HD/SD SDI to  HDMI 1.4 signal without scaling artifacts.

Up to 8 channels of 3G/HD/SD-SDI audio channels are re- embedded in the HDMI stream.

The SFP features a HDMI type D connector with a retention clip that locks with cables EB00CC04-02C (DVI) and EB00CC04-02C (HDMI).


  • SMPTE 424M, SMPTE 292M, and SMPTE 259M, SMPTE 425A (Mapping 1), SMPTE 425B (372M Mapping)
  • SDI Reclocked Loopback to host connector
  • Supported format: 525/625, 720p/1080i (50/ 59.94/60 Hz), 1080p (23.98/24/25/29.97/30/50/ 59.94/60 Hz)
  • HDMI Output:
    • 24bit (3x8bit), BW=150MHz
    • RGB 4:4:4, YCbCr 4:2:2, YCbCr 4:4:4
    • DVI 1.0 Mode
    • RGB Range (Full/SMPTE)
    • Up to 8 channel audio embedding (PCM)
  • HDMI 1.4 type D connector
  • HDMI type D plug with locking mechanism available (EB00CA04 Cable Assembly series)
  • Hot-pluggable
  • Control via serial interface including:
    • EDID reading
    • HDMI interface configuration
    • Audio mapping
    • Voltage & Temperature Monitoring
    • Module Information
  • Low Power Consumption – typical 1032mW
  • Single Supply +3.3V
  • Pb-free and RoHS compliant
  • Operating temperature range: -20°C to 80°C
  • 64.1mm x 13.4mm x 8.6mm SFP Package
  • Ganged Cages & Stacked Cages mounting supported


  • Low Cost HDMI (Non-HDCP) Input Solution